Proxim ORiNOCO Przewodnik Instalacji Pobierz pdf (Strona 130)

Troubleshooting

ORiNOCO® 802.11n Access Points - Software Management Guide 130

8.2 Connectivity Issues

Connectivity issues include any problem that prevents you from powering up or connecting to the device.

There is No Data

Link Established

• Verify that the indicator on the device port is “ON.”

• Verify that the PoE Injector hub is properly connected to the ethernet port of the

device.

• Verify that the ethernet cable is Category 5 or better and is less than 100 meters

(approximately 325 feet) in length from the ethernet port of the device to the PoE.

• Try to connect a different device to the same port on the PoE Injector hub – if it works

and a link is established then there is probably a fault in the data link of the device.

• Try to re-connect the cable to a different output port (remember to move the input

port accordingly) – if it works then there is a fault probably in the output or input port

of the PoE Injector hub or a bad RJ45 connection.

Power Overload

Indications

• Connect the device to a PoE Injector.

• Ensure that there is no short over on any of the connected cables.

• Move the device into a different output port (remember to move the input port

accordingly) - if it works then there is a fault probably in the previous RJ45 port or bad

RJ45 port connection.

Problem Solution

Device Does Not

Boot / No LED

Activity

See The Device Does Not Boot / Power ON / Initialize

Ethernet Link Does

Not Work

Check the ethernet LED. The color of the Ethernet LED indicates the speed of the Ethernet

traffic:

Try connecting the device:

• To a different port on the PoE and/or a switch.

• Through a different Ethernet Category 5/Category6 cable.

Ethernet LED Color Speed

Red 100 Mbps

Green 1000 Mbps

OFF No link is available or Ethernet is not connected

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 177 178

Brak uwag

Proxim ORiNOCO Przewodnik Instalacji Strona 130